User`s manual

195
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring User Encryption
195D-Link Systems, Inc.
8. Enable the WEP40 cipher suite in service prole wpa-wep-for-mac. Type the following
command:
DWS-1008# set service-prole wpa-wep-for-mac cipher-wep40 enable
success: change accepted.
TKIP is already enabled by default when WPA is enabled.
9. Enable PSK authentication in service prole wpa-wep-for-mac. Type the following
command:
DWS-1008# set service-prole wpa-wep-for-mac auth-psk enable
success: change accepted.
10. Congure a passphrase for the preshared key. Type the following command:
DWS-1008# set service-prole wpa-wep-for-mac psk-phrase “passphrase to convert
into a preshared key”
success: change accepted.
11. Display the WPA conguration changes. Type the following command:
DWS-1008# show service-prole wpa-wep-for-mac
ssid-name: voice ssid-type: crypto
beacon: yes auth-fallthru: none
WEP Key 1 value: <none> WEP Key 2 value: <none>
WEP Key 3 value: <none> WEP Key 4 value: <none>
WEP Unicast Index: 1 WEP Multicast Index: 1
Long Preamble: YES Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: pre-shared key
TKIP countermeasures time: 60000ms
pre-shared-key: 92f99cd49e186cadee13fda7b2a2bac78975 a5723a4a6b31b5b5395d6
b001dbe
12. Map service prole wpa-wep-for-mac to radio prole rp3. Type the following commands:
DWS-1008# set radio-prole rp3 service-prole wpa-wep-for-mac
success: change accepted.
13. Apply radio prole rp3 to radio 1 on port 4 and to radios 1 and 2 on port 6 and enable
the radios, and verify the conguration changes. Type the following commands:
DWS-1008# set ap 4,6 radio 1 radio-prole rp3 mode enable
success: change accepted.
DWS-1008# set ap 6 radio 2 radio-prole rp3 mode enable
success: change accepted.