User`s manual
187
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring User Encryption
187D-Link Systems, Inc.
After you type this command, the service prole supports both TKIP and CCMP.
Displaying RSN Settings
To display the RSN settings in a service prole, use the following command:
show service-prole {name | ?}
The RSN settings appear at the bottom of the output.
Note. The RSN-related elds appear in the show service-prole output only when RSN is
enabled.
Assigning the Service Prole to Radios and Enabling the Radios
After you congure RSN settings in a service prole, you can map the service prole to a radio
prole, assign the radio prole to radios, and enable the radios to activate the settings.
To map a service prole to a radio prole, use the following command:
set radio-prole name service-prole name
To assign a radio prole to radios and enable the radios, use the following command:
set ap port-list radio {1 | 2} radio-prole name mode {enable | disable}
To map service prole rsn to radio prole bldg2, type the following command:
DWS-1008# set radio-prole blgd2 service-prole rsn
success: change accepted.