User`s manual

181
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring User Encryption
181D-Link Systems, Inc.
The table below lists the encryption support for WPA and non-WPA clients.
Encryption Support for WPA and Non-WPA Clients
MSS
Encryption
Type
Client Encryption Type
WPA—
CCMP
WPA—TKIP
WPA—
WEP40
WPA—
WEP104
Dynamic
WEP
Static WEP
WPA—CCMP
Supported
WPA—TKIP
Supported
WPA—WEP40
Supported Supported
WPA—WEP104
Supported Supported
Dynamic WEP
Supported
Static WEP
Supported
Conguring WPA
To congure DWL-8200AP access point radios to support WPA:
1. Create a service prole for each SSID that will support WPA clients.
2. Enable the WPA IE in the service prole.
3. Enable the cipher suites you want to support in the service prole. (TKIP is enabled
by default.) Optionally, you also can change the countermeasures timer value for
TKIP.
4. Map the service prole to the radio prole that will control IEEE settings for the
radios.
5. Assign the radio prole to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this authentication method
and enter an ASCII passphrase or a hexadecimal (raw) key.
Creating a Service Prole for WPA
Encryption parameters apply to all users who use the SSID congured by a service prole.
To create a service prole, use the following command:
set service-prole name