User`s manual

172
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
Displaying Connection Information for Distributed APs
A Distributed AP can have only one active data connection. To display the system IP address
of the switch that has the active connection, use the following command:
show dap connection [dap-num | serial-id serial-ID]
The serial-id parameter displays the active connection for a Distributed AP even if that AP is
not congured on this switch. However, if you use the command with the dap-num parameter
or without a parameter, connection information is displayed only for Distributed APs that are
congured on this switch.
Displaying Service Prole Information
To display service prole information, use the following command:
show service-prole {name | ?}
Entering show service-prole ? displays a list of the service proles congured on the
switch.
To display information for service prole wpa_clients, type the following command:
DWS-1008# show service-prole wpa_clients
ssid-name: D-Link ssid-type: crypto
beacon: yes auth-fallthru: last-resort
WEP Key 1 value: <none> WEP Key 2 value: <none>
WEP Key 3 value: <none> WEP Key 4 value: <none>
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
Displaying Radio Prole Information
To display radio prole information, use the following command:
show radio-prole {name | ?}
Entering show radio-prole ? displays a list of radio proles.