User`s manual

168
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
To map a radio prole to a service prole, use the following command:
set radio-prole name service-prole name
The following command maps service-prole wpa_clients to radio prole rp2:
DWS-1008# set radio-prole rp2 service-prole wpa_clients
success: change accepted.
Assigning a Radio Prole and Enabling Radios
To assign a radio prole to radios, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} radio-prole name mode {enable | disable}
To assign radio prole rp1 to radio 1 on ports 1-3, and 6 and enable the radios, type the
following command:
DWS-1008# set ap 1-3,6 radio 1 radio-prole rp1 mode enable
success: change accepted.
To assign radio prole rp1 to radio 2 on ports 1-4 and port 6 and enable the radios, type the
following command:
DWS-1008# set ap 1-4,6 radio 2 radio-prole rp1 mode enable
success: change accepted.
To disable radio 1 on port 6 without disabling the other radios using radio prole rp1, type
the following command:
DWS-1008# set ap 6 radio 1 radio-prole rp1 mode disable
Disabling or Reenabling Radios
You can disable or reenable radios on a radio prole basis or individual basis. You also can
reset a radio to its factory default settings.
Enabling or Disabling Individual Radios
To disable or reenable an access point radio, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} mode {enable | disable}
To disable radio 2 on port 3 and 5, type the following command:
DWS-1008# set ap 3,5 radio 2 mode disable
success: change accepted.