User`s manual

167
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
The parameters are shown in separate commands for simplicity. However, you can use the
channel and tx-power parameters on the same command line.
Specify 1 or 2 for the radio number:
• For an 802.11b/g radio on a DWL-8220AP specify radio 1.
• For an 802.11a radio specify radio 2.
Note: The maximum transmit power you can congure on any D-Link radio is the highest
setting allowed for the country of operation or the highest setting supported on the hardware,
whichever is lower.
To congure the 802.11b radio on port 2 for channel 1 with a transmit power of 10 dBm,
type the following command:
DWS-1008# set ap 2 radio 1 channel 1 tx-power 10
success: change accepted.
To congure the 802.11a radio on port 5 for channel 36 with a transmit power of 10 dBm,
type the following command:
DWS-1008# set ap 5 radio 2 channel 36 tx-power 10
success: change accepted.
You also can change the channel and transmit power on an individual basis.
Conguring the External Antenna Model
The DWL-8220AP has an internal antennas but can use an external antennas. The
DWL-8220AP uses the internal antennas by default.
To specify the external antenna model, use the following command:
set {ap port-list | dap dap-num} radio
{1 antennatype ANT1060 | ANT1120 | ANT1180 | internal} |
{2 antennatype ANT5060 | ANT5120 | ANT5180 | internal}
To congure antenna model ANT-1060 for a DWL-8220AP on Distributed AP 1, type the
following command:
DWS-1008# set dap 1 radio 1 antennatype ANT1060
success: change accepted.
Mapping the Radio Prole to Service Proles
To assign SSIDs to radios, you must map the service proles for the SSIDs to the radio prole
that is assigned to the radios.