User`s manual

166
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
Removing a Radio Prole
To remove a radio prole, use the following command:
clear radio-prole name
Note: You must disable all radios that are using a radio prole before you can remove the
prole.
To disable the radios that are using radio prole rptest and remove the prole, type the
following commands:
DWS-1008# set radio-prole rptest mode disable
DWS-1008# clear radio-prole rptest
success: change accepted.
Conguring Radio-Specic Parameters
The following parameters are specic to individual radios and are not controlled by a radio
prole:
• Channel number
• Transmit power (in decibels referred to 1 milliwatt)
• External antenna model (if applicable)
These parameters have the following defaults:
• Channel number:
• The default channel number for 802.11b/g is 6.
• The default channel number for 802.11a is the lowest valid channel number for
the country of operation.
• Transmit power - Highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower
• External antenna model - internal antenna used by default
Conguring the Channel and Transmit Power
Note: If RF Auto-Tuning is enabled for channels or power, you cannot set the channels or
power manually using the commands in this section.
To set the channel and transmit power of a radio, use the following commands:
set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level