User`s manual

12
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Conguration
CLI Quickstart Command
The quickstart command runs a script that interactively helps you congure the following
items:
• System name
• Country code (regulatory domain)
• System IP address
• Default route
• Administrative users and passwords
• Unencrypted (clear) SSID names
• Encrypted (crypto) SSID names and dynamic WEP encryption for encrypted SSIDs’
wireless trafc
• Usernames and passwords for secure access using 802.1X authentication using
PEAP-MSCHAP-V2 and secure wireless data encryption using dynamic Wired
Equivalent Privacy (WEP)
• Directly connected DWL-8220AP access points
• Distributed access points
The quickstart command displays a prompt for each of these items, and lists the default
if applicable. You can advance to the next item, and accept the default if applicable, by
pressing Enter. Depending on your input, the command also automatically generates the
following key pairs and self-signed certicates:
• SSH key pair (always generated)
• Admin key pair and self-signed certicate (always generated)
• EAP (802.1X) key pair and self-signed certicate (generated if you type
usernames and passwords for users of encrypted SSIDs)
The command automatically places all ports that are not used for directly connected access
points into the default VLAN (VLAN 1).
Caution: The quickstart command is for conguration of a new switch only. After prompting
you for verication, the command erases the switch’s conguration before continuing. If you
run this command on a switch that already has a conguration, the conguration will be
erased. In addition, error messages such as Critical AP Notice for directly connected MPs
can appear.