User`s manual

158

DWS-1008 User’s Manual

D-Link Systems, Inc.

Conguring DWL-8220AP Access Points

The ngerprint is displayed regardless of whether it has been veried in MSS.

Note: The show dap cong command lists an AP’s ngerprint only if the ngerprint has

been conrmed in MSS. If the ngerprint has not been conrmed, the ngerprint info in the

command output is blank.

Verifying a Fingerprint on the Switch

To verify a DWL-8220AP’s ngerprint on a switch, use the following command:

set dap num ngerprint hex

Where hex is the 16-digit hexadecimal number of the ngerprint. Use a colon between each

digit. Make sure the ngerprint you enter matches the ngerprint used by the AP.

The following example sets the ngerprint for Distributed AP 8:

DWS-1008# set dap 8 ngerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3

success: change accepted.

Setting the AP Security Requirement on a switch

Note: A change to AP security support does not affect management sessions that are already

established. To apply the new setting to an AP, restart the AP.

To congure AP security requirements, use the following command:

set dap security {require | optional | none}

The following command congures an DWS-1008 to require Distributed APs to have encryption

keys:

DWS-1008# set dap security require

Fingerprint Log Message

If AP encryption is optional, and an AP whose ngerprint has not been conrmed in MSS

establishes a management session with the switch, MSS generates a log message such as

the following:

DAP-HS:(secure optional)conﬁgure DAP 0335301065 with ﬁngerprint c6:98:9c:41:32:

ab:37:09:7e:93:79:a4:ca:dc:ec:fb

The message lists the serial number and ngerprint of the AP. You can check this information

against your records to verify that the AP is authentic.