User`s manual

157
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
AP Security Requirements
AP
Security
Setting
AP Has
Fingerprint
Fingerprint
Veried in
MSS?
AP Can Establish
Management Session
with Switch?
AP
Security
Required
Yes Yes Yes
No No
No Not Applicable No
AP
Security
Optional
Yes Yes Yes
1
No Yes
1
No Not Applicable Yes
1.MSS generates a log message listing the AP serial number and ngerprint so you can verify the AP’s
identity.
Verifying a DWL-8220AP’s Fingerprint on a switch
To verify a DWL-8220AP’s ngerprint, nd the ngerprint and use the set dap ngerprint
command to enter the ngerprint in MSS.
Finding the Fingerprint
A DWL-8220AP’s ngerprint is listed on a label on the back of the AP. If the AP is already
installed and operating, use the show dap status command to display the ngerprint. The
following example shows information for Distributed AP 8, including its ngerprint:
DWS-1008# show dap status 8
Dap: 8, IP-addr: 10.2.26.40 (vlan ‘default’), AP model: DWL-8220AP,
manufacturer: D-Link, name: DAP08
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x29f1886d447f111a ram=33554432
s/n=0424000779 hw_rev=A3
Uptime: 1 hours, 8 minutes, 17 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 1 operational power: 1
base mac: 00:0b:0e:0a:60:00
bssid1: 00:0b:0e:0a:60:00, ssid: public
bssid2: 00:0b:0e:0a:60:02, ssid: default
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 48 operational power: 11
base mac: 00:0b:0e:0a:60:01
bssid1: 00:0b:0e:0a:60:01, ssid: public
bssid2: 00:0b:0e:0a:60:03, ssid: default