User`s manual

153
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
802.1X Port uses authentication parameters
congured for users.
Port groups Not applicable
IGMP snooping Enabled as users are authenticated and join
VLANs.
Maximum user
sessions
Not applicable
Caution: When you set the port type for AP use, you must specify the PoE state (enable or
disable) of the port. Use the switch’s PoE to power D-Link DWL-8220APs only. If you enable
PoE on a port connected to another device, physical damage to the device can result.
To set the port type for AP access ports, use the following command:
set port type ap port-list
model {DWL-8220AP} poe {enable | disable} [radiotype {11a | 11b| 11g}]
You must specify the AP model and the PoE state.
You can specify one of the following for the radio type:
• 11a - 802.11a
• 11b - 802.11b
• 11g - 802.11g
The DWL-8220AP has two radios. One radio is always 802.11a. The other radio is 802.11b/g,
but can be congured for 802.11b or 802.11g exclusively. If the country of operation specied
by the set system countrycode command does not allow 802.11g, the default is 802.11b.
The DWL-8220AP has an internal 802.1b/g antenna as well as a connector for an external
antenna, so use of an external antenna is optional. It also has a connector for an optional
external 802.11a antenna. To specify the antenna model, use the set {ap | dap} radio
antennatype command.
AP radios congured for 802.11g also allow associations from 802.11b clients by default.
To set ports 1 through 4 and port 6 for the DWL-8220AP and enable PoE on the ports, type
the following command:
DWS-1008# set port type ap 1-4,6 model dwl-8220ap poe enable
This may affect the power applied on the configured ports. Would you like to continue? (y/
n) [n]y
Conguring an Indirectly Connected AP
If a DWL-8220AP access point that you want to manage using the switch is indirectly
connected to the switch through a Layer 2 or Layer 3 network, congure the AP using the
following command:
set dap dap-num serial-id serial-ID model {DWL-8220AP} [radiotype {11a | 11b| 11g}]