User`s manual

151
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
Displaying Status Information for APs Congured by the Template
To display status information for APs congured by the template, type the following
command:
DWS-1008# show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan ‘default’), AP model: DWL-8220AP,
manufacturer: D-Link, name: AP100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id= ram=33554432
s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public
bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public
bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
The output displays auto next to the Distributed AP number to indicate that the AP was
congured using a template.
Converting a DWL-8220AP Congured by the Template into a Permanent
AP
You can convert a temporary AP conguration created by the template into a persistent AP
conguration on the switch. To do so, use the following command:
set dap auto persistent {dap-num | all}
This command creates a persistent Distributed AP conguration based on the settings in the
template. The Distributed AP name and number assigned by the template are used for the
persistent entry. For example, if the template assigned the number 100 and the name AP100
to the AP, the persistent conguration for the AP has the same number and name. In this
case, use 100 as the dap-num with show dap, set dap, or clear dap commands.
The AP continues to operate without interruption after you enter the set dap auto persistent
command. The next time the AP is restarted, the template is not used to congure the AP.
Instead, the persistent conguration is used. (Use the save cong command to make the AP
conguration persistent across switch restarts.)