User`s manual

150
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
APs that receive their congurations from the template also receive the radio settings from
the radio prole used by the template. Likewise, the SSIDs and encryption settings come
from the service proles mapped to the radio prole. To use a radio prole other than default,
you must specify the radio prole you want to use.
Changing AP Parameter Values
The commands for conguring AP and radio parameters for the template are the same as the
commands for conguring an individual Distributed AP. Instead of specifying a Distributed AP
number with the command, specify auto.
AP Parameters:
set dap auto mode {enable | disable}
set dap auto bias {high | low}
set dap auto upgrade-rmware {enable | disable}
set dap auto group name
set dap auto blink {enable | disable}
Radio Parameters:
set dap auto radiotype {11a | 11b| 11g}
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-prole name mode {enable | disable}
set dap auto radio {1 | 2} auto-tune max-power power-level
set dap auto radio {1 | 2} auto-tune max-retransmissions retransmissions
set dap auto radio {1 | 2} auto-tune min-client-rate rate
Enabling the Template
To enable the template for automatic Distributed AP conguration, type the following
command:
DWS-1008# set dap auto mode enable
success: change accepted.
Specifying the Radio Prole Used by the Template
The template uses radio prole default by default. To use another radio prole instead, use
the following command:
set dap auto radio {1 | 2} radio-prole name mode {enable | disable}
The following command changes the template to use radio prole autodap1 for radio 1:
DWS-1008# set dap auto radio 1 radio-prole autodap1
success: change accepted.
Note: You must congure the radio prole before you can apply it to the template.