User`s manual

149
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
To display the AP settings in the template, type the following command:
DWS-1008# show dap cong auto
Dap auto: mode: disabled bias: high
fingerprint
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: 15, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
This example shows the defaults for the AP parameters you can congure in the template. The
table below lists the congurable template parameters and their defaults. The only parameter
that requires conguration is the template mode. The template is disabled by default. To use
the template to congure Distributed APs, you must enable the template.
Congurable Template Parameters for
Distributed APs
Parameter Default Value
AP Parameters
mode disabled
bias high
upgrade-rmware (boot-
download-enable)
enable (YES)
group (load balancing
group)
none
blink
(Not shown in show dap
cong output)
disable
Radio Parameters
radiotype (type)
(Applies only to single-
radio AP models)
11g
(or 11b for country codes
where 802.11g is not
allowed)
mode enabled
tx-pwr Highest setting allowed
for the country of
operation
radio-prole (prole) default
max-power default
min-client-rate 5.5 for 802.11b/g
24 for 802.11a
max-retransmissions 10