User`s manual

145
DWS-1008 User’s Manual
D-Link Systems, Inc.
Conguring DWL-8220AP Access Points
rts-threshold 2346 Transmits frames longer
than 2346 bytes by means
of the Request-to-Send/
Clear-to-Send (RTS/CTS)
method.
service-prole No service
proles
dened
Default settings for all
service prole parameters,
including encryption
parameters, are used.
short-retry 5 Sends a short unicast
frame up to ve times
without acknowledgment.
wmm enable Prioritizes trafc based
on the Wi-Fi Multimedia
(WMM) standard.
RF Auto-Tuning
The RF AutoTuning feature dynamically assigns channel and power settings to AP radios,
and adjusts those settings when needed. RF AutoTuning can perform the following tasks:
• Assign initial channel and power settings when a DWL-8220AP radio is started.
• Periodically assess the RF environment and change the channel or power setting if
needed.
• Change the transmit data rate or power to maintain at least the minimum data rate
with all associated clients.
By default, RF AutoTuning is enabled for channel conguration but disabled for power
conguration.
Default Radio Prole
MSS contains one default radio prole, named default. To apply common parameters to
radios, you can modify the default prole or create a new one. When you create a new prole,
the radio parameters in the prole are set to their factory default values.
Radio-Specic Parameters
The channel number, transmit power, and external antenna parameters are unique to each
radio and are not controlled by radio proles. The table below lists the defaults for these
parameters.