User`s manual

DWS-1008 User’s Manual

D-Link Systems, Inc.

Installation Overview

Caution: The DWS-1008 switch has been designed and tested to be installed in an operating

ambient temperature of 0° C to +40° C (32° F to 104° F). To reduce the risk of equipment

damage, install equipment with consideration to these ambient conditions.

Serial Console Cable

The serial console port has a female DB-9 connector and supports the EIA-232D signaling

standard. You need a standard DB-9-male-to-DB-9-female PC modem cable.

Serial Console Pin Signals

Switch Pin Usage PC Pin Usage

2 Receive 3 Transmit

3 Transmit 2 Receive

5 Ground 5 Ground

10/100 Ethernet Cable Wiring

Connections on the 10/100 ports require CAT5 cable based on the EIA/TIA-586 standard.

The 10/100 Ethernet ports on the DWS-1008 switch provide automatic MDI/MDX, which

automatically crosses over the send and receive signals if required.

The table below lists the pin signals for 10/100 Ethernet straight-through wiring. Pins 4, 5,

7, and 8 are used only when Power over Ethernet (PoE) is enabled on the port. RD means

Receive Data and TD means Transmit Data.

DWS Switch Other Device

Pin Function Pin Function

1 RD+ 1 TD+

2 RD- 2 TD-

3 TD+ 3 RD+

4 PoE+ 4 PoE+

5 PoE+ 5 PoE+

6 TD- 6 RD-

7 PoE- 7 PoE-

8 PoE- 8 PoE-

Note: Mounting a DWL-8220AP access point on a solid surface requires CAT5 cable that

does not have strain relief. For installation on all other surfaces, you can use CAT5 cable

with or without strain relief.