Setup guide

3 X 5s Aggregate traffic in packets/sec
4 X 5s Aggregate traffic in bits/sec
5 X 5s Software version and build info
6 X 5s ether1
7 X 5s prism1
[admin@Wandy] system lcd page> enable [find]
[admin@Wandy] system lcd page> print
Flags: X - disabled
# DISPLAY-TIME DESCRIPTION
0 5s System date and time
1 5s System resources - cpu and memory load
2 5s System uptime
3 5s Aggregate traffic in packets/sec
4 5s Aggregate traffic in bits/sec
5 5s Software version and build info
6 5s ether1
7 5s prism1
[admin@Wandy] system lcd page>
To set "System date and time" to be displayed for 10 seconds:
[admin@Wandy] system lcd page> set 0 display-time=10s
[admin@Wandy] system lcd page> print
Flags: X - disabled
# DISPLAY-TIME DESCRIPTION
0 10s System date and time
1 5s System resources - cpu and memory load
2 5s System uptime
3 5s Aggregate traffic in packets/sec
4 5s Aggregate traffic in bits/sec
5 5s Software version and build info
6 5s ether1
7 5s prism1
[admin@Wandy] system lcd page>
LCD Troubleshooting
Description
LCD doesn't work, cannot be enabled by the '/system lcd set enabled=yes' command.
Probably the selected serial port is used by PPP client or server, or by the serial console. Check the
availability and use of the ports by examining the output of the /port print command. Alternatively,
select another port for connecting the LCD, or free up the desired port by disabling the related
resource
LCD doesn't work, does not show any information.
Probably none of the information display items have been enabled. Use the /system lcd set
command to enable the display.