Setup guide

NOTE: if Framed-IP-Address or Framed-Pool is specified it overrides
remote-address in default configuration
Idle-Timeout overrides idle-timeout in default configuration
Session-Timeout overrides session-timeout in default configuration
Class cookie, will be included in Accounting-Request
unchanged
Framed-Route !!format is specified in RFC2865 (Ch. 5.22)!!,
can be specified as many times as needed.
Filter-Id firewall filter chain name. It will be used
to make dynamic firewall rule that will jump
to specified chain, if incoming or outgoing
interface will be client PPP, PPTP, PPPoE interface.
Firewall chain name can have suffix .in or .out,
that will install rule only for incoming or outgoing
traffic. Multiple filter-id can be provided, but
only last ones for incoming and outgoing will
used.
Acct-Interim-Interval overrides interim-update from RADIUS client, if
0 uses the one specified in RADIUS client.
MS-MPPE-Encryption-Policy
overrides require-encryption in default configuration
(PPPs only)
MS-MPPE-Encryption-Type
overrides use-encryption in default configuration,
non 0 value means use encryption (PPPs only)
Ascend-Data-Rate tx/rx data rate limitation (for PPPoE, Hotspot only)
if multiple attributes are provided, first limits
tx data rate, second - rx data rate.
0 if unlimited.
MS-CHAP2-Success auth. response if MS-CHAPv2 was used (for PPPs only)
MS-MPPE-Send-Key
and MS-MPPE-Recv-Key encryption keys for encrypted PPP, PPTP and PPPoE,
provided by RADIUS server only is MS-CHAPv2 was
used as authentication (for PPP, PPTP, PPPoE only)
Wandy-Recv-Limit total recv limit in bytes for the client (Hotspot only)
Wandy-Xmit-Limit total transmit limit in bytes for the client
(Hotspot only)
Framed-IP-Netmask client network netmask (Hotspot only)
Ascend-Client-Gatway client gateway (Hotspot only)
Accounting-Request
Acct-Status-Type Satrt, Stop, or Interim-Update
Acct-Session-Id accounting session ID
Service-Type same as in request (PPPs only)
Framed-Protocol same as in request (PPPs only)
NAS-Identifier same as in request
User-Name same as in request
NAS-Port-Type same as in request
NAS-Port-Id same as in request
Calling-Station-Id same as in request (PPPs) (Hotspot from v2.6.9)
Called-Station-Id same as in request (PPPs) (Hotspot from v2.6.9)
Acct-Authentic authenticated by whom (PPPs only).
Framed-IP-Address IP address given to the user
Class RADIUS server cookie (PPPs only)
Stop and Interim-Update Accounting-Request
Acct-Session-Time connection uptime in seconds
Acct-Input-Octects bytes received from the client
Acct-Input-Packets nubmer of packets received from the client
Acct-Output-Octets bytes sent to the client
Acct-Output-Packets number of packets sent to the client