Installation guide

20
Using the Configuration Menu
Tools > Admin
SNMP (Simple Network Management Protocol) is a widely used network monitoring and
control protocol. The DWL-1000AP+ supports SNMP V1. SNMP allows one computer
on the network (the administrator) to monitor the devices on the network and to perform
management functions.
New Password: Enter the new password
Confirm Password: Re-enter the password to confirm it
Enabled is the default selection. Select Disabled to disable it.
System Location: enter a name for information only (e.g., “Accounting”)
System Contact: enter a name for information only (e.g., “John”)
Community: If you enter a community “name” here, you must enter the same
“name” on the SNMP tool before you can use the management functions
Trap Receiver:
1: enter IP address of the computer that will receive trouble alerts
2:
3:
enter IP address of the computer that will receive trouble alerts
enter IP address of the computer that will receive trouble alerts