User`s manual

DVG-G1402S User’s Manual

D-Link Systems, Inc.

Using the Conﬁguration Utility (continued)

Using the Conﬁguration Utility

Host Name:

MAC Address:

Clone MAC Address:

Primary/Secondary

DNS Address:

Apply:

Enter a host name. Most ISPs do not require this.

If you are using the computer that was last connected directly to

the modem, click the Clone MAC Address button.

Home > WAN > Dynamic IP

Manually enter the MAC address of the computer that was last

connected directly to the Internet. Most cable ISPs will authenticate

by the MAC address of the device that is connected to the modem

(router or computer). Few ISPs require you to register the MAC

address with them. In most cases, turning off the power to the

modem for 3-5 minutes will allow you to use a new device to

connect.

You may enter the DNS if supplied by your ISP. Leave blank if you

do not know or were supplied with DNS server IP addresses.

Click Apply to save your settings. After the router reboots, you

may need to unplug the power to your modem for about 1 minute

and plug back in. Allow up to 3 minutes to connect to the Internet.

In most cases, you should be able to connect right away.