User`s manual

DVG-5121SP User’s Manual
D-Link Corporation
42
5-3-5. Firewall
Advanced Network Setting > Security > Firewall
Firewall: Select Enable or Disable.
Active: Select Yes or No.
Action: Select Allow or Deny.
Source: Choose WAN or LAN as the Source and enter a range of IP Addresses on the Internet that you would like
this rule applied to. Enter the IP Address of the computer on your local network that you want to allow the
incoming service to. This will not work with a range of IP Addresses.
Destination: Select LAN or WAN as the Destination and enter the IP Address of the computer on your local network
that you want to allow the incoming service to. This will not work with a range of IP Addresses. Enter
the port or range of ports that are required to be open for the incoming service.
Schedule: The schedule of time when the firewall will be enabled. The schedule may be set to Always,
which allows the particular firewall to always be enabled. If it is set to By Schedule, select the time frame
for the firewall to be enabled.
Log: Select Enable or Disable.