User manual

11D-Link DUB-E100 User Manual
Section 2 - Installation
8. Once you have completed the driver installation, plug the DUB E100’s USB cable into an available USB port on your
computer.
9. Attach an Ethernet cable to the Ethernet port on the DUB-E100.
10. Attach the other end of the Ethernet cable to your network switch or router.
11. When the installation of the DUB-E100 is complete, the LINK LED should be solid green, indicating a good physical
connection between the DUB-E100 and the network. The Tx/Rx LED blinks when data is being transmitted or received.
If both LEDs are unlit, there may be a problem with the physical connection. Check the cables between your DUB-E100
and your switch or router. Verify that your network switch or router is powered on.