Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 63
Section 5 - Connect to the Internet
IPv6
IP Mode
Path: Network > IPv6 > IP Mode
This page allows you to congure the IP protocol version to be used on the router. In order to support IPv6 on
your local network (LAN), you must set the router to be in IPv4 / IPv6 mode. This mode will allow IPv4 nodes to
communicate with IPv6 devices through this router.
To enable IPv6 on the router:
1. Click Network > IPv6 > IP Mode.
2. Select IPv4 & IPv6.
3. Click Save.