Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 23
Section 4 - LAN Conguration
UPnP Setup
Path: Network > LAN > UPnP
Universal Plug and Play (UPnP) is a feature that allows the router to discover devices on the network that can
communicate with the router and allow for auto-conguration. If a network device is detected by UPnP, the
router can open internal or external ports for the trac protocol required by that network device. If disabled, the
router will not allow for automatic device conguration and you may have to manually open/forward ports to
allow applications to work.
To congure the UPnP settings:
1. Click Network > LAN > UPnP.
2. Toggle Activate UPnP to On.
3. Select a VLAN from the LAN Segment drop-down menu.
4. Enter a value for Advertisement Period. This is the frequency that the router broadcasts UPnP information
over the network. A large value will minimize network trac but cause delays in identifying new UPnP
devices to the network.
5. Enter a value for Advertisement Time to Live. This is the number of steps a packet is allowed to propagate
before being discarded. Small values will limit the UPnP broadcast range. A default of 4 is typical for
networks with a few number of switches.
6. Click Save.
7. Your entry will be displayed in the UPnP Port Map List. To edit or delete, right-click an entry and select
the action from the menu. Repeat steps 2-6 to add multiple entries.