Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 288
Appendix D - Log Output Reference
%s: %s, dev->name, buf DEBUG
%s: cannot allocate space for SHA1
digest, fname
ERROR
%s: no memory for sysctl table!, __func__ DEBUG %s%d: trying to write outside history ERROR
%s: failed to register sysctls!, vap->iv_dev->name DEBUG %s%d: trying to write outside history ERROR
Atheros HAL assertion failure: %s: line %u: %s, DEBUG %s%d: trying to write outside history ERROR
ath_hal: logging to %s %s, ath_hal_logle, DEBUG
%s%d: too big uncompressed packet:
%d,
ERROR
ath_hal: logging disabled DEBUG
%s%d: encryption negotiated but not
an
ERROR
%s%s, sep, ath_hal_buildopts[i] DEBUG
%s%d: error - not an MPPC or MPPE
frame
ERROR
ath_pci: No devices found, driver not installed. DEBUG
Kernel doesn’t provide ARC4 and/or
SHA1 algorithms
ERROR
---:%d pri:%d qd:%u ad:%u sd:%u tot:%u amp:%d
%02x:%02x:%02x,
DEBUG PPP: not interface or channel?? ERROR
SC Pushbutton Notify on %s::%s,dev->name,vap-
>iv_dev->name
DEBUG PPP: no memory (VJ compressor) ERROR
Could not nd Board Conguration Data DEBUG failed to register PPP device (%d), err ERROR
Could not nd Radio Conguration data DEBUG PPP: no memory (comp pkt) ERROR
%s: No device, __func__ DEBUG ppp: compressor dropped pkt ERROR
ath_ahb: No devices found, driver not installed. DEBUG PPP: no memory (VJ comp pkt) ERROR
PKTLOG_TAG %s:proc_dointvec failed, __
FUNCTION__
DEBUG PPP: no memory (comp pkt) ERROR
PKTLOG_TAG %s:proc_dointvec failed, __
FUNCTION__
DEBUG PPP: no memory (fragment) ERROR
%s: failed to register sysctls!, proc_name DEBUG PPP: VJ uncompressed error ERROR
PKTLOG_TAG %s: proc_mkdir failed, __
FUNCTION__
DEBUG ppp_decompress_frame: no memory ERROR
PKTLOG_TAG %s: pktlog_attach failed for %s, DEBUG
ppp_mp_reconstruct bad seq %u <
%u,
ERROR
PKTLOG_TAG %s:allocation failed for pl_info,
__FUNCTION__
DEBUG PPP: couldn’t register device %s (%d), ERROR
PKTLOG_TAG %s:allocation failed for pl_info,
__FUNCTION__
DEBUG
ppp: destroying ppp struct %p but
dead=%d
ERROR
PKTLOG_TAG %s: create_proc_entry failed for %s, DEBUG ppp: destroying undead channel %p !, ERROR
PKTLOG_TAG %s: sysctl register failed for %s, DEBUG
PPP: removing module but units
remain!
ERROR
PKTLOG_TAG %s: page fault out of range, __
FUNCTION__
DEBUG PPP: failed to unregister PPP device ERROR
PKTLOG_TAG %s: page fault out of range, __
FUNCTION__
DEBUG JBD: bad block at oset %u, ERROR
PKTLOG_TAG %s: Log buer unavailable, __
FUNCTION__
DEBUG JBD: corrupted journal superblock ERROR
PKTLOG_TAG DEBUG JBD: bad block at oset %u, ERROR