Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 256
Appendix D - Log Output Reference
Facility: System (Firewall)
Log Message Severity Log Message Severity
Enabling rule for protocol binding. DEBUG Disable all NAT rules. DEBUG
Disabling rule for protocol binding. DEBUG Enable all NAT rules. DEBUG
Enabling Remote SNMP on WAN. DEBUG Enabling NAT URL lter rules. DEBUG
Disabling Remote SNMP on WAN DEBUG Restarting all NAT rules. DEBUG
wan trac counters are restared DEBUG Deleting schedule based rewall rules. DEBUG
Trac limit has been reached DEBUG
Deleting schedule based rewall rules
from DB.
DEBUG
Trac meter monthly limit has been
changed to %d.
DEBUG
Update schedule based rewall rules in
DB.
DEBUG
Enabling trac meter for only dowload. DEBUG Restart schedule based rewall rules. DEBUG
Enabling trac meter for both directions. DEBUG inter vlan routing enabled DEBUG
Enabling trac meter with no limit. DEBUG inter vlan routing disabled DEBUG
Email alert in trac meter disabled. DEBUG Disabling Content Filter for %d DEBUG
Email alert in trac meter enabled. DEBUG Enabling Content Filter for %d DEBUG
Trac Meter:Monthly limit %d MB has
been “
DEBUG
./src/rewall/linux/user/
rewalld.c:59:#undef ADP_DEBUG2
DEBUG
Trac Metering: Adding rule to drop all
trac
DEBUG
./src/rewall/linux/user/
rewalld.c:61:#dene ADP_DEBUG2
printf
DEBUG
Trac Metering: %sabling Email trac DEBUG Enabling Source MAC Filtering DEBUG
Disabling attack checks for IPv6 rules. DEBUG Disabling Source MAC Filtering DEBUG
Enabling attack checks for IPv6 rules. DEBUG
Adding MAC Filter Policy for Block &
Permit Rest
DEBUG
Conguring one to one NAT settings with
%s private start IP “
DEBUG
Adding MAC Filter Policy for Permit &
Block Rest
DEBUG
Deleting forward one to one NAT having
setting %s private start”
DEBUG Restarting Source MAC Address Policy DEBUG
Disabling attack check for Block ping to
WAN interface.
DEBUG
Disabling Firewall Rule for DHCP Relay
Protocol
DEBUG
Disabling attack check for Stealth mode
for tcp
DEBUG
Enabling Firewall Rule for DHCP Relay
Protocol
DEBUG
Disabling attack check for Stealth mode
for udp
DEBUG
prerouting Firewall Rule add for Relay
failed
DEBUG