Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 192
Section 9 - Maintenance
Log Settings
The router allows you capture log messages. You can monitor the type of trac that goes through the router
and be notied of potential attacks or errors when they are detected by the controller. The following sections
describe the log conguration settings and the ways you can access these logs.
Dening What to Log
Path: Maintenance > Logs Settings > Log Facilities
The Facility Logs page lets you determine the granularity of logs to receive from the wireless controller. Select
one of the following facilities:
• Kernel: The Linux kernel. Log messages that correspond to this facility would correspond to
trac through the rewall or network stack.
• System: Application and management-level features available on this router for managing the
unit.
• Local1-UTM: This facility corresponds to IPS (Intrusion Prevention System) which helps in
detecting malicious intrusion attempts from the WAN.
• Local0-Wireless: This facility corresponds to the 802.11 driver used for providing AP
functionality to your network.
1. Click Maintenance > Log Settings > Log Facilities.
2. Select the facility and then toggle ON which events you want to log and click Save.