Manual
Table Of Contents
- Preface
- Introduction
- Installation
- Basic Configuration
- LAN Configuration
- Connect to the Internet
- Wireless Settings
- VPN
- Security
- Maintenance
- Status and Statistics
- Troubleshooting
- Appendix A - Glossary
- Appendix B - Factory Default Settings
- Appendix C - Standard Services for Port Forwarding & Firewall Configuration
- Appendix D - Log Output Reference
- Appendix E - RJ-45 Pin-outs
- Appendix F - New Wi Fi Frequency table ( New appendix section )
- Appendix G - Product Statement
D-Link DSR-Series User Manual 90
Section 6 - Wireless Settings
4. Once enabled the following screen will appear.
5. Under WPS Setup Method, decide to either use PIN or PBC (Push Button).
6. If you want to use PIN method, enter the PIN next to Station PIN and click Congure Via PIN. You will
need to enter the PIN on your wireless client and start the WPS process within one minute.
7. If you want to use push button method, click Congure Via PBC. This will initiate the WPS session. You
will need to press the WPS button (or initiate through an interface) on your client within one minute.
8. Allow up to two minutes to connect. Check the Session Status to see if it successfully connected.