User`s guide

XStack Storage User’s Guide 99
5.3.6 Logging on to the iSCSI Initiator Computer
After you create a volume (Section 5.2.3), an iSCSI initiator (Section 5.3.2), a network portal
(Section
5.3.4), and an iSCSI target nodes (Section 5.3.3), use the following procedure to log on
to the Microsoft iSCSI initiator.
1. Connect the appropriate XStack Storage Ethernet port to the NIC in the iSCSI initiator
computer using an Ethernet RJ-45 cable.
2. Start the Microsoft iSCSI initiator application:
When Microsoft iSCSI Initiator starts, the iSCSI Initiator Properties dialog box appears.
3. Click the Discovery tab.
4. Click Add to add a target portal. The Add Target Portal dialog box appears.
5. Enter the IP address of the target network portal that this iSCSI initiator will use to access
the requested volumes.
6. Click OK. The IP address you entered (192.168.1.115 in the example in
Figure 5-36)
appears in the Discovery tab.
Figure 5-36. Discovery Tab on the iSCSI Initiator Properties Dialog Box