User`s guide

92 Chapter 5 Configuring the XStack Storage
After you create network portals, you can monitor their status using the
Portals Information screen (refer to Section
6.3.5).
5.3.4.3 Modifying Network Portal Parameters
There may be times when you need to change the IP address or subnet mask for a network
portal. To modify a network portal’s configuration settings, use the following procedure.
1. Delete the network portal following the steps outlined in section
5.3.4.4
2. Create a new network portal with the desired IP address and subnet mask as outlined in
section
5.3.4.2.
5.3.4.4 Deleting Network Portals
If you no longer need a network portal, use the following procedure to delete it.
A warning message does not appear before you delete a network portal.
Therefore, be sure you do not need the network portal before you delete it.
1. In the Logical Resources tab, click the network portal you want to delete.
2. Perform one of the following steps to delete the network portal:
– On the Network menu, click Delete Network Portal.
– Right-click and click Delete Network Portal.