User`s guide

88 Chapter 5 Configuring the XStack Storage
5.3.3.3 Adding or Deleting Physical Ports in a LAG
There may be times when you want to add physical ports to or delete physical ports from a LAG.
The following steps describe this procedure. As you add or remove physical ports, record the
information in
Table D-3 on page 166.
1. In the Logical Resources tab, click a LAG whose physical port you want to configure.
2. On the Network menu, click Config Physical Port. The Add/Remove Ethernet Ports for LAG
Wizard starts and the Add/Delete Ethernet Ports screen appears (see
Figure 5-27).
Figure 5-27 Add/Remove Ethernet Ports for LAG Wizard - Add/Delete Ethernet Ports screen
3. To add Ethernet ports, select one or more ports in the left box and click Add to move them
to the right box.
4. To remove one or more Ethernet ports, select them in the right box and click Remove to
move it to the left box.
5. When you finish adding Ethernet ports, click the Finish button.