User`s guide

XStack Storage User’s Guide 87
5.3.3.2 Modifying LAG Parameters
There may be times when you need to modify LAG parameters. Using the XStack Storage
management console, you can view the Maximum Transmission Unit (MTU) size and requested
speed. As you modify LAG parameters, record the information in
Table D-3 on page 166.
To modify LAG parameters, use the following procedure.
1. In the Logical Resources tab, click the LAG whose parameters you want to change.
2. Perform one of the following steps:
– On the Network menu, click Modify LAG Parameters.
– Right-click and click Modify LAG Parameters.
– Either step displays the Modify LAG Parameters screen appears (see
Figure 5-26).
Figure 5-26 Modify Lag Parameters Dialog Box
3. Complete the fields in the dialog box:
– MTU Size. This value specifies the maximum size of a packet that can be transferred in
one frame over a network.
– Requested Speed. This value indicates the requested speed for transmitting and sending
packets. For the XStack Storage4 and XStack DSN-3200, the choices are Auto Detect, 100
Mbps, and 10 Mbps. For the XStack DSN-3400, the only choice is 10Gb.
4. Click OK.