Installation Instructions Part 1

Section 3 – Configuration
D-Link DSL-2640R User Manual 20
PPPoE/PPPoA
To set up a PPPoE or PPPoA connection:
1. Choose the PPPoA/PPPoE option under ISP in the Encapsulation
section.
2. Most users will not need to change ATM settings in the ATM VC section.
If this is the first time you are setting up the ADSL connection it is
recommended that you leave the ATM QoS type and associated Cell
Rate settings at the default values until you have established the
connection and verified that your ISP supports ATM for your ADSL
account. However, if you are instructed to change the VPI or VCI values,
type in the values assigned for your account. Leave the Virtual Circuit
and Status settings at the defaults (Pcv0 and Activated) values for now.
These can be used later if you are configuring multiple virtual circuits for
your ADSL service.
3. Most users will not need to change QoS settings. If this is the first time
you are setting up the ADSL connection it is recommended that you leave
the settings at the default values until you have established the
connection. Please see the table on ATM QoS in the next section of this
manual for further information.
4. In the PPPoE/PPPoA section, type the Username and Password used
for your ADSL account. A typical User Name will be in the form
[e-mail]
. Your ISP may assign the Password to you or you
may have selected it when you set up the account with your ISP.
5. Choose the Encapsulation setting from the pull-down menu. This
defines the encapsulation method used for your ADSL service. The
available options are PPPoE LLC, PPPoE VC-Mux, PPPoA LLC, and
PPPoA VC-Mux. If you have not been provided specific information for
this section, leave the default setting.
Follow the instructions to configure the Router to use a PPPoA or PPPoE for the
Internet connection. Make sure you have all the necessary information before you
configure the Internet (WAN) connection.