Specifications

DSL-504T Generation II ADSL2+ Modem Router
Rear Panel Connections
All cable connections to the Router are made at the rear panel. Connect the power adapter here to power on
the Router. Use the Reset button to restore the settings to the factory default values in the next chapter for
instructions on using the reset button).
Connect network cables:
1. Insert the ADSL (telephone) cable included with the Router into the ADSL port and then connect the cable
to your telephone line.
2. Insert one end of the Ethernet cable into the Ethernet (LAN) port on the back panel of the Router and the
other end of the cable to an Ethernet Adapter or available Ethernet port on your computer.
Reset
To Reset the Router to factory default settings including the default IP address 10.1.1.1, depress the reset
button on the right side panel with a ballpoint pen, paper clip or similar object for a few seconds. The device
will restart with default settings.
Ethernet Ports
Use the Ethernet ports
to connect the Router to
your Ethernet LAN or
computers
Power Insert
Use the adapter
shipped with the
Router to connect to
power source
ADSL Port
Use the ADSL cable to connect to
the your telephone line (RJ-11
port)
Reset
To manually reset, depress button
with the power on for at least
seven seconds
Page 11 of 96 www.dlink.com.au