User manual
18D-Link DSL-500B User Manual
Installation
The DSL-500B maintains two separate interfaces: ADSL (WAN) and an Ethernet (LAN). Place the Router in a
location where it can be easily connected to Ethernet devices, the telephone line, and a power source.
The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the front of
the device, should you ever need to view them for troubleshooting.
Power On
The Router must be used with the power adapter included with the device.
Connect the power adapter to the 1. Power receptacle (12V DC, 1A) on the rear panel of the Router and plug the
other end of the power adapter to a wall outlet or power strip.
Push the 2. On/Off button on the rear panel of the Router to turn the power on.
The 3. Power LED on the front panel will turn bright green to indicate the device is powered on.
If the Ethernet port is connected to a working device, check the 4. LAN LED indicator to make sure the connection
is valid. The Router will attempt to establish the ADSL connection, if the ADSL line is connected and the Router is
properly congured, the ADSL LED will light up after several seconds. If this is your rst time installing the device,
some settings may need to be changed before the ADSL Router can establish a connection.
Device Installation