User manual

29D-Link EBR-2310 User Manual
Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to page 28.
Enter a name for the rule or select an application from the drop-down
menu. Select an application and click << to populate the fields.
Enter the IP address of the computer on your local network that you
want to allow the incoming service to. If your computer is receiving
an IP address automatically from the router (DHCP), you computer
will be listed in the “Computer Name” drop-down menu. Select your
computer and click <<.
Enter the port that you want to open next to Private Port and Public
Port. The private and public ports are usually the same. The public
port is the port seen from the Internet side, and the private port is
the port being used by the application on the computer within your
local network.
Select TCP, UDP, or Both from the drop-down menu.
The schedule of time when the Virtual Server Rule will be enabled.
The schedule may be set to Always, which will allow the particular
service to always be enabled. You can create your own times in the
Tools > Schedules section.
Name:
IP Address:
Private Port/
Public Port:
Traffic Type:
Schedule: