User manual

DSL-2750E User Manual
80
Click Add below the table IPTUNNEL to add tunnel items. The page shown in the
following figure appears.
The following table describes the parameters of this page.
Field Description
Tunnel Name Set a tunnel name.
Tunnel Mode Select the tunnel mode as 4 in6 or 6in4.
Wan Interface Choose a WAN interface used for the tunnel.
Lan Interface Choose a LAN interface used for the tunnel.
Click Apply to enable the settings.
Click Add below the table DS-Lite IPv4 over IPv6 Tunnel List to add a DS-Lite
item，which is a 4in6 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field Description
Mechanism The tunnel type is DS-Lite, which is 4in6 tunnel.
Dynamic Set the obtaining mode of remote IPv6 addresses.
You can select 0 or 1.
RemoteIPv6Address Set the remote end IPv6 address of the tunnel.