User`s guide

19
9. The Connection Established window appears. Internet service is now established.
Click close and the Diagnostic tool icon appears on the task bar.
RFC 1483 Bridged Ethernet over ATM
1. The Update Device Driver Wizard will detect the DSL-100 as a PCI Network
Controller, click Next.
2. Insert the driver CD.
3. The Update Device Driver Wizard will appear and indicate that Windows was
unable to locate a driver for this device. Click Other Locations.
4. When Select Other Location window appears, enter the path to your CD ROM
drive. For example, D:\1483w95.
5. The Update Device Driver Wizard will then find the ADSL PCI NIC. Click
Finish.
6. The Insert Disk window appears. Insert the PCI NIC CD. Click OK.
7. The Copying Files window appears. Again type in your systems CD drive
location letter and driver e.g. D:\1577w95 and click OK.
8. When the Service Option window appears, click Advanced.
9. The Service Options window now displays the Connection Address and Select
ADSL Mode sections.
In the Network Protocol and PVC setting section, select Ethernet over ATM, then
enter in the VPI and VCI values provided by your ADSL service provider.
10. The previous Service Option window will appear, click Next.
11. Proceed to Making an Internet connection for Bridged Ethernet.
Windows NT 4.x
You must be logged in as an Administrator in order to properly install and configure the
DSL-100. Verify that TCP/IP is installed prior to the installation.
Point-to-Point Protocol over ATM
1. Double click My Computer and then go to Control Panel.
2. In the Control Panel, double click the Network icon and select the Adapters tab
and click Add.
3. Select Network Adapter window appears. Click Have Disk.
4. Insert the driver CD.
5. The insert Disk window appears. Enter the CD’s drive letter followed by a colon
and a backslash. Enter 2364NT4 and click OK.
6. The Select OEM Option window will find the DSL-100. Click OK when it does.