User`s guide

16
ATM and then enter in the VPI and VCI values provided by our ADSL service
provider. Make sure the Framing is set to VC MUX.
In the Select ADSL Mode section, select the mode recommended by your ADSL
service provider. Click on the mode required and then click OK.
6. The previous Service Option window will appear, click Next.
7. The system Setting change window appears. Click Yes to restart your computer
now.
8. When you are finished the Diagnostic Tool icon is active and monitoring
connectivity. You must now make a network connection.
RFC 1483 Bridged Ethernet over ATM
1. The New Hardware Found wizard will detect the DSL-100 as a PCI Network
Controller. Select the Driver from disk provided by hardware manufacturer
option. Click OK.
2. Insert the Driver CD into the CD ROM drive.
3. The Install From Disk window appears. Enter the drive letter and path to the CD.
For example: D:\1483w95. Then click OK.
4. When the Service Option window appears, click Advanced.
5. The Service Options window now displays the Connection Address and Select
ADSL Mode sections.
In the Network Protocol and PVC setting section, select Ethernet over ATM, then
enter in the VPI and VCI values provided by your ADSL service provider.
In the Select ADSL Mode section, select the mode recommended by your ADSL
service provider. Click on the mode required and then click OK.
6. The previous Service Option window will appear, click Next.
7. At the conclusion of the driver installation, the Diagnostic Tool icon will appear
disabled on the Taskbar. You must now Restart the PC system to complete the
installation, the Diagnostic Tool will then become active.
8. Proceed to Making an Internet connection from Bridged Ethernet.