User`s guide
15
Windows 95A
Follow the appropriate steps for the protocol you are using. You may need to copy files
from your Windows 95 CD. Windows will ask for the CD if it needs to copy files. If you
receive the message “File Not Found” when you copy files from the CD enter the path to
your CD (CD drive letter>:\Win95).
RFC 2364 – Point to Point Protocol over ATM
1. Windows detects the DSL-100 as a PCI Network Controller and displays the New
Hardware Found window.
2. Select the “Driver from disk provided by hardware manufacturer” option and
Click OK.
3. Insert the driver CD. The Install From Disk window appears. In the text entry
labeled Copy manufacture’s files from: type in your system’s CD drive location
letter followed by a colon (:) and then a backslash (\), then type “2364w9x”. It
should look like this: D:\2364w9x. Then click OK.
4. Click Advanced when the Service Option Window Appears.
5. The Service Options window now displays the Connection Address and Select
ADSL Mode sections.
In the Network Protocol and PVC Settings section, enter the VPI and VCI values
provided by your ADSL service provider. Verify that Framing is set to VC MUX.
In the Select ADSL Mode section, select the mode(s) recommended by your
ADSL service provider. Click on the mode(s) required and then click OK.
6. The previous Service Option window will appear, click Next.
7. When the driver installation is complete, the Diagnostic Tool icon is active and
monitoring connectivity. You must now make a network connection.
RFC 1577 Classical Internet Protocol over ATM
1. The New Hardware Found window will detect the card as a PCI Network
Controller. Select the Driver from disk provided by hardware manufacturer option
and click OK.
2. Insert the DSL-100 driver CD into the drive.
3. The Install From Disk window appears. In the text entry bar labeled Copy
manufacture’s files from your CD ROM drive’s location letter and the path. For
example, D:\1577w95 to copy the 1577w95 files to your drive. Click OK.
4. When the Service Option window appears, click Advanced.
5. The Service Option window now displays the Connection Address and Select
ADSL Mode sections.
In the Network Protocol and PVC Setting section, select the Classical IP over