Installation guide

Baby Explorer 1.3 Installation Guide
14 26-Aug-2005
Validated Devices
We have validated the following devices:
• AVerMedia AverTV
• AVerMedia DVD EZMaker USB2.0*
• Belkin USB VideoBus II
• D-Link DSB-V100
• Imaging Source DFG/1394
• ViewCast Osprey-100
• ViewCast Osprey-200
* Preferred device
Installing the Device
This procedure depends on the type of video capture device you have.
> To install a PCI-based video capture device
1. Turn off the workstation.
2. Open the workstation’s case.
3. Insert the video capture card into an empty PCI slot on the motherboard.
4. Close the workstation’s case.
Note: We recommend that you wait until after you install the license dongle (see
“Installing the License Dongle” on page 15) before you turn on the workstation
again.
> To install a USB video capture device
1. Turn off the workstation.
2. Insert the video capture device cable into a USB port located on the back of the
workstation. If the USB ports are already occupied, you can attach a USB hub to
provide more ports and plug in additional devices, as needed.
Note: We recommend that you wait until after you install the license dongle (see
“Installing the License Dongle” on page 15) before you turn on the workstation
again.