User manual

Setting up the DPR-1040
D-Li
nk DPR-1040 User Manual 14
Wireless Setup
WPS (Push Button Configuration)
WPS simplifies the process of connecting to a wireless network to a touch of a
button. To use WPS you must have a WPS compatible wireless router, if you do not
then you will need to manually configure the wireless connection in the web
configurator (see Web Configurator below).
1. After following the hardware installation steps in section 3, ensure your wireless
network is operating normally. When ready, press the WPS button located on the
side of the DPR-1040. The blue LED should start flashing repeatedly.
2. Within 120 seconds, press the WPS button located on the wireless router you will
be connecting to. This button may also be located in the router’s web
configuration pages labeled “Push Button Configuration (PBC)”.
3. If successful, a wireless connection will be established between the two devices.
This connection is secure and uses automatically generated encryption keys; you
do not need to remember them.
Note: If you experience problems connecting to a device, please try again. If you still
experience problems, the device you’re connecting to may be incompatible with the
DPR-1040. Also, make sure you are connecting to a router or access point (AP).