User`s guide

Save these parameters after modification from the browser. These parameters will be
saved to flash and the H.323 phone will restart with new parameters. Now the H.323
phone will play
call progress tone and try to get IP parameters from DHCP server. If
successful, the H.323 phone will try to register with the H.323 Gate Keeper (GK). If the
H.323 phone succeeds in the above two operations it will play a dial tone and is ready
for use. If either operation fails it will play an error tone and the H.323 phone is not
functional.
D-Link H.323 phones can work without H.323 servers through the phone book. For this
mode, configure the phone book through browser and the phones will work with
configurations in the phone book. Note that phone-book entries of all the phones in one
network should be consistent.
D-Link H.323 phones supports a feature whereby you can restart the H.323 phone with
factory defaults. This is useful if you want to configure the H.323 phone through the
browser and you don’t have the H.323 phone IP address. This feature updates the
configurable parameters to default values.
Note: The factory defaults can’t be modified after being burned to flash unless the flash
is reprogrammed. Thus the factory should burn the correct MAC address to factory
defaults.
The software will not work if the MAC chip is other than DL-10022A.
To access the web interface for the D-Link DPH-80:
Use a JavaScript-enabled Internet browser (Netscape 6.2 or above, IE 5.0 or above)
with the default IP address of the DPH-80 entered in the address box (http://10.1.1.80
).
The following page will appear.
10.2.1. Login Page
The following two parameters control access to the SIP phone. Default value for both
will be "dlink". These values can be changed later using the Change Login Name and
Password Page.
User Name: This is case-insensitive with a maximum of 20 characters.
48