User`s guide
Table Of Contents
- Overview
- Unpacking and Installation
- Getting Started
- Internet Phone Calls
- PSTN Phone Calls
- DPH-70 Configuration
- Additional Features
- Appendix A: Procedure for entering alphanumeric and special
- Appendix B: Troubleshooting
- All outgoing calls are PSTN calls. It does not dial in Inter
- “Please configure the phone and try again”
- “Please check the phone line and try again”
- “Password entered is incorrect. Try again”
- “The ISP line is busy, please call after some time”
- “The ISP server is not responding”
- “ISP connection could not be established, try later”
- “Please check your ISP parameters and try again”
- “Bad phone line, Please contact customer support”
- “Please check your calling card parameters and try again”
- “The number you have dialed is not locatable, please check t
- “The number you have called is busy, please call after some
- “Incorrect value. Press ‘1’ to edit, ‘2’ to skip”
- Fast error tone for a short period while disconnection phone
- All outgoing calls are PSTN calls. It does not dial in Inter
- Appendix C: DPH-70 Product Specifications
DPH-70 User’s Guide
8.3 Entering Capital Letters
You need to press a SHIFT button and a digit key, specified number of times, to enter the capital
letters marked on digit keys. SHIFT LED turns on after SHIFT button is pressed and turns off after
the digit key is pressed.
• Press a SHIFT button and then the digit key, the following number of times to enter the
capital letters.
o Twice to enter the capital of the first letter written on that key.
o Thrice to enter the capital of the second letter written on that key.
o Four times to enter the capital of the third letter written on that key.
o Five times to enter the capital of the fourth letter written on that key.
• If the key is pressed once after SHIFT button is pressed, it accepts the corresponding
digit.
• If the key is pressed more than above mentioned times after the SHIFT button is pressed,
it accepts as a last capital letter written on that key.
Examples: To enter A, press SHIFT followed by key 2 two times.
To enter E, press SHIFT followed by key 3 three times.
To enter Z, press SHIFT followed by key 9 five times.
NOTE: Press the appropriate key firmly, specified number of times, in quick succession to enter
alphabets.
8.4 Entering Special Characters
Press DIAL UP button and then press the corresponding key mentioned in table below to
enter special characters. DIAL UP LED turns on after pressing the DIAL UP button and turns
off after accepting a special character.
Special
Character
Description
Key To be
pressed
“Backspace”
0
@ “At ”
1
. “Dot”
2
- “Hyphen”
3
_ “Underscore”
4
$ “Dollar”
5
& “Ampersand”
6
/ “Slash”
7
: “Colon”
8
# “Hash”
9
Note: Backspace can be used to delete the unwanted character. It will delete the last entered
character.
Examples: To enter @, press DIAL UP followed by key 1.
To enter ., press DIAL UP followed by key 2.
To delete the last character, press DIAL UP followed by key 0.
23