User`s guide
Table Of Contents
- Overview
- Unpacking and Installation
- Getting Started
- Internet Phone Calls
- PSTN Phone Calls
- DPH-70 Configuration
- Additional Features
- Appendix A: Procedure for entering alphanumeric and special
- Appendix B: Troubleshooting
- All outgoing calls are PSTN calls. It does not dial in Inter
- “Please configure the phone and try again”
- “Please check the phone line and try again”
- “Password entered is incorrect. Try again”
- “The ISP line is busy, please call after some time”
- “The ISP server is not responding”
- “ISP connection could not be established, try later”
- “Please check your ISP parameters and try again”
- “Bad phone line, Please contact customer support”
- “Please check your calling card parameters and try again”
- “The number you have dialed is not locatable, please check t
- “The number you have called is busy, please call after some
- “Incorrect value. Press ‘1’ to edit, ‘2’ to skip”
- Fast error tone for a short period while disconnection phone
- All outgoing calls are PSTN calls. It does not dial in Inter
- Appendix C: DPH-70 Product Specifications
DPH-70 User’s Guide
7 Additional Features
7.1 Upgrading Software
DPH-70 has a facility to upgrade the software, remotely through the Internet at no cost to you.
Software can be downloaded when the phone is in RECEIVE state or when not in use.
On pressing ‘∗456∗#’, the phone connects to the Internet and downloads the software. During the
download process, DPH-70 will play progress tone and blink the SHIFT LED. After successful
download, the phone restarts with the newer software. Due to some reason if download fails, the
phone will continue working with the earlier software. You can check the current software version
through configuration menu.
D-Link will release latest DPH-70 software in its website at
http://www.dlink.co.in along with the
server IP address from where the latest software can be downloaded. This information is required
to be entered into DPH-70 through the configuration menu.
Note: On pressing ‘*456*#’, DPH-70 will ask for confirmation.
7.2 Loading factory defaults
If it is required to reset DPH-70 and start with default configuration parameters, you can do so by
pressing ‘∗789∗#’ while DPH-70 is in idle state. The phone restarts in few seconds with the
default parameters. Default configuration password is ‘12345’. The phone needs to be configured
again for Internet access and calling card information before it can be used.
Note: On pressing ‘*789*#’, DPH-70 will ask for confirmation.
21