Installation guide

86
Ethernet
configuration
Network: After enabling, the phone will try to
connect network.
Ethernet configuration: Tap the Ethernet
configuration button, it will pop up a "Configure
Ethernet device" dialog, and then do the following
configurations, after configuring, you can tap "OK"
button to make settings take effect.
DHCP: Use DHCP to connect network.
DNS server address automatically: Whether to use
DNS assigned by DHCP server to connect network.
Static IP: Whether to use static IP to connect network.
IP: Input your assigned IP address.
Netmask: Input your assigned Netmask.
Gateway: Input your assigned Gateway.
DNS address: Input your assigned DNS address.
DNS2 address: Input your assigned DNS2 address.
PPPoE set
username: Input your assigned PPPoE account
username.
password: Input your assigned PPPoE password.
Auto connect on power up: Whether to automatically
connect PPPoE on booting.
After the configuration is completed, if you click
"Connect" button, it will connect to the network using
PPPoE mode at once;If you click "OK" button, it will
only save the configuration parameters; If you click
"cancel" button, the parameters you have been set will
not be saved.
Auto reconnect: When connecting failed whether to
automatically connect PPPoE.
6.1.2 Sound & display
Tap "Basic settings", then select "sound & display" to switch to sound &
display interface.
Configuration item Meaning
Volume Set
Silent mode: Set whether to enable Silent mode. After
enabling the function, all sounds will not take effect
expect media volume and alarm clock.
Ringer volume: Adjust the volume size of incoming
call.
Media volume: Adjust the volume size of media.
Ring Set
Phone ringtone: Set telephone ringtone of incoming