User`s guide

Internet Server User’s Guide
AT Commands 63
0
Go on-hook (hang-up)
1
Go off-hook
In
Identification Command
0
Display the product identification code.
1
Report pre-computed checksum.
2
Report O.K.
3
Report firmware revision, model and interface
type.
4
Report response programmed by an OEM.
5
Report the country code parameter.
6
Report modem data pump model and code ver-
sion.
Ln
Speaker Volume
0
Off
1
Low (Default)
2
Medium high
3
High
Mn
Speaker Control
0
Speaker always off
1
Speaker on during handshaking and off while
receiving carrier. (Default)
2
Speaker on during handshaking and while re-
ceiving carrier.
3
Speaker off during dialing and receiving carrier
and turn speaker on during answering.
Nn
Automode Detection – This command interacts
with the F command and should be thus used.
0
Disabled
1
Enabled (Default)
On Return to Data Mode – after using +++ command
to switch to command mode.