User`s guide

DP-300 Multiprotocol Fast Ethernet Print Server User’s Guide
Unpacking and Installation
9
on/steady off on/steady Timer INT error
on/steady off flashing LAN IO Base error
on/steady on/steady off RAM error
flashing off off Parallel-1 Controller error
flashing flashing off Flash erase/program error
flashing flashing flashing Need to reload firmware
Testing Your DP-300
The
PS Admin
software includes a Print Test function for confirmation of
printer cable connections and functions. That operational test can be
completed after you have installed the
PS Admin
software, and have
configured your DP-300 and its ports. See the
Testing Your Print Server
section of the
Print Server Administration User’s Guide
.
Wall-Mounting the DP-300
The bottom of the DP-300’s case has a pair of wall-mount sockets, and
screws and nylon anchors are supplied, to facilitate mounting the DP-300 to
a wall or partition adjacent to your printers.
To mount the DP-300 with the front panel facing up (and the printer port
connectors facing down), set the two mounting screws at the lower-left and
upper-right corners of a rectangle as shown below (actual size):