User manual

36D-Link DNS-722-4/DNS-726-4 User Manual
Section 3 - Configuration
Schedule Configuration
Set Recording Schedule Conguration
Step 1: Enter the desired Start Time and End
Time.
Step 2: Enter pre-record period and post-record for
event trigger recording.
Step 3: Check the enable audio box to record audio
from your camera (if supported).
Step 4: Choose the recording mode and the trigger
source.
Step 5: Press OK to add this new schedule.
Step 6: If you would like to add another new schedule,
click the Insert button.
Note
• TheAlways Record option will start recording immediately.
• WhenconguringtheMotionDetectionevent,besuretosetupthemotiondetectionfunctiononyourcamerarst.
• Afterchangingthemotiondetectionsettingsofyourcamera,besuretodisconnectthecamerafromtheNVRandthenre-connectittoupdateallnew
changes.
• Whensettingupanevent,avideomotionordigitalinputcanbeusedtotriggertheothercameras.Thismeansthatwhenmotionisdetectedbyacamera,
the NVR can send out warning signals to the other connected cameras.
• Alternativelyuserscandragthetimebartochangetherecordingperiod.TheredbarrepresentstheAlways Record feature and the blue bar represents
the Event Recording feature.
*DNS-722-4doesnotsupport“Recordonevent”function.