Installation guide

25
 “OSD: 10 SEC” is the amount of ti me the system name will be displayed on the monitor after the
computer is selected. This value can be se t from 05 sec to 99 sec. The factory default value is 10 sec.
 “SCAN TIME” is the scan interval from one PC port to next PC during Auto Scan mode. The default
scan time is 10 sec and the max imum scan time is 99 sec.
 “CHANGE PASSWORD” is used t o change the password for acces sing the systems. The default
password is 8 digits “00000 000“.
 An enter password window appears when you select this item . The maximum password is 8 digi ts .
Af ter you key in t he passwo rd and press the <Enter> key , anoth er window appears to confirm the
password you entered.
 You need to retype the password again to verify .
 “CONSO LE ON /OFF“ determines whether the password needs to be entered to access the console.
“CONSOLE ON” means that any user can access the console. “CONSOLE OFF”
means that t he passwo rd needs to be entered t o access the cons ole. Once the password is
entered once
to access the conso le , this value will be set to “CONSOLE ON”. Remember to set it to “CONSOLE OFF”
again if you want t o lock it af t er closing the console. Also, if the current CONSO LE is ON state and you
reset KVM switch, the CONSOLE will set the ON s tate back t o OFF state.
 When you finish setting the system name and exit the OSD mode, you will find the active system
name displayed at the top-lef t corner of monito r . You can press the <Esc> key to clear the message right
away if you don’t need it.
 If you want the OSD to return back to factory default value, you can enter the key combination <Scroll
Lock>, <Scroll Lock>, <R>. The seven segment Bank LEDs on the front panel will flash during the refresh
process.